Vass S Series Electrobar

Vass Electrobar is a proven Australian designed and manufactured power distribution system which solves the problems of wiring and rewiring industrial, commercial buildings, retail outlets, data centres and telephone exchanges …….. Or anywhere where safe, economical and flexible power is required.

Simply bolt sections together to suit the floor layout. Single or three-phase power is available with outlets every 150mm (6"). No more complicated cable runs and no more sub-boards because Vass Electrobar acts as sub-board, sub-main and even final sub-circuit!

Altering layouts is simply a matter of unplugging and relocating!

Vass Electrobar is a complete electrical distribution system. It eliminates the expense of installing conventional wiring. It eliminates sub-boards and the space needed to access them.

Experience shows that the installed costs of Busway Systems are more economical than conventional wiring systems.

However further, major savings are possible once the system is installed. Should you want to add lights, power points or machinery, simply plug them in to the Electrobar. Maintenance costs are greatly reduced too.

Changes to floor plans and movements of plant are simpler, faster and involve no additional cost.
As the various installations photographs show, Vass Electrobar suits almost any power distribution requirement. The S Series illustrated has single phase ratings up to 150A and three phase and neutral up to 700A.

Some of the plug-in units are shown. Extending the system is simply a matter of undoing the termination cap and bolting on another section. For major redesigns it is easy to unbolt the sections and reassemble - you can even take your system when you relocate to new premises!

Power Distribution for Factories, Workshops, Shopping Centres, Communication Centres…, or anywhere requiring Simplicity, versatility and economy.

Vass S-Series Electrobar is a prefabricated, standardised, ready-to-erect Busway System for electrical power distribution featuring the extreme simplicity of the exclusive "Plug In" power take -off boxes. Once installed, the Electrobar Busway System will take care of electric power distribution and relocation of any equipment only requires unplugging and plugging the power take-off box into the new position.

All Vass plug-in take-off-boxes are fully interchangeable over all Busway ratings from 80 to 700 amps.

This Busway system is available in an indoor rated system or in a version offering IP54 degree of protection for wet areas.

Vass Electrobar plug-in Busway Systems are designed and manufactured in Australia to comply with the relevant stringent requirements of Australian Standards. Vass Electrobar Busways are accepted by all authorities throughout Australia.

more info

Vass S SeriesTake-off Boxes

Vass take off boxes are manufactured to the highest of standards. The boxes are available in a wide range of configurations.

more info